• 联系人:小马师傅
  • 电话:18560041881
  • 地址:济南市北园大街86号
新闻中心当前位置:首页-新闻中心
    来源:http://www.jndmzp.com/   时间:
    环氧自流平地板漆的使用寿命有多长?
    来源:http://www.jndmzp.com   时间:2020-5-12 9:59:18
    地坪漆的使用寿命有多长?问得好。每个人都关心它。它能持续多久完全取决于你。这要看你用的是哪一种环氧地坪漆,比如一种环氧地坪漆,通常为0.5-0.8毫米,使用寿命为5-8年。环氧砂浆地坪漆,一般1- 5mm,使用寿命8-10年;环氧自流平地坪涂料一般为1- 5mm,使用寿命为10-15年。当然,这也取决于你是否对地板漆做过维护。我们的衣服将送到干洗店去熨。它给人的感觉就像新的一样,就像地板漆的维护一样。
    How long is the service life of floor paint? Good question. Everyone cares about it. How long it lasts depends entirely on you. It depends on which kind of epoxy floor paint you use, for example, an epoxy floor paint, usually 0.5-0.8mm, with a service life of 5-8 years. Epoxy mortar floor coating, generally 1-5mm, with a service life of 8-10 years; epoxy self leveling floor coating, generally 1-5mm, with a service life of 10-15 years. Of course, it also depends on whether you have done maintenance on the floor paint. Our clothes will be sent to the dry cleaner for ironing. It feels like new, like floor paint maintenance.
    环氧地坪漆的使用寿命与环氧地坪的清洁和保养密切相关。特别是在停车场,每天都有很多车进进出出。汽车轮胎在停车场和车道外的道路上携带着泥土和沙子,使车道容易受到污染和损坏。因此,以上区域应每天彻底清洁。
    The service life of epoxy floor paint is closely related to the cleaning and maintenance of epoxy floor. Especially in the parking lot, there are many cars in and out every day. Car tires carry soil and sand in the parking lot and on the road outside the lane, which makes the lane vulnerable to pollution and damage. Therefore, the above areas should be thoroughly cleaned every day.
    1. 环氧地坪漆在固化期间,严禁任何人员和设备进入,并采取防雨防水措施。固化期通常至少为7天。达到养护期后才能投入使用。
    1. During the curing period of epoxy floor paint, no personnel and equipment are allowed to enter, and rainproof and waterproof measures are taken. The curing period is usually at least 7 days. It can only be put into use after reaching the maintenance period.
    2. 一般情况下,环氧地坪结构在7天(25°c)后完全稳定,达到理想的物理化学性能。
    2. Generally, the epoxy floor structure is completely stable after 7 days (25 ° C), and achieves ideal physical and chemical properties.
    3.环氧地坪漆是保持地面清洁卫生所必需的。建议铺地时更换软底鞋(如胶鞋)。如有粉尘颗粒、破碎颗粒等硬物质。应及时清理,防止硬物、尖锐物直接摩擦地面,以免压碎后损坏地面。工作人员不应该把他们从外面带进来。

    3. Epoxy floor paint is necessary to keep the floor clean. It is recommended to replace soft soled shoes (such as rubber shoes) when laying the floor. If there are dust particles, broken particles and other hard substances. It shall be cleaned in time to prevent hard and sharp objects from directly rubbing the ground, so as to avoid damaging the ground after crushing. The staff should not bring them in from outside.

    当灰尘进入,不同的叉车用于内部和外部场合。
    When dust enters, different forklifts are used for internal and external occasions.
    4、用力重物一定要轻放,以免机器过重,将物体直接打在地板上油漆,避免尖锐物体划伤。
    4. The heavy objects must be placed gently to avoid over weight of the machine, and the objects shall be directly hit on the floor to paint, so as to avoid sharp object scratch.
    6、一般地面清洗和保养方法可采用清洗和保养,日常清洗可采用软拖把和抹布清洗。
    6. General ground cleaning and maintenance methods can use cleaning and maintenance, daily cleaning can use soft mop and cloth cleaning.
    按照上述方法,地板漆的使用寿命可以更长。环氧地坪涂料在施工过程中,各种问题的产生是由各种原因造成的,其中最常见的是由于薄膜表面的局部收缩而形成的斑点。以下是环氧地坪漆表面产生斑点的原因分析:原因是环氧地坪漆中添加了太多的表面活性低的添加剂,如硅油。解决方案:控制硅油等表面活性剂的用量。原因是溶剂或稀释剂中含有太多的低沸点和高沸点溶剂,比例不合适。解决方案:应注意使用低沸点和高沸点溶剂以及各种沸点溶剂的比例。原因是涂层表面的油脂、蜡、金属皂和湿气没有被清除。残留的酸和碱将留在被涂物体的表面。解决方案:环氧地坪漆施工前,应清除地坪漆表面的油污、蜡、金属皂、残留酸、残留碱和水。原因是在喷涂过程中引入了油或水,喷涂距离物体表面太近。
    According to the above method, the service life of floor paint can be longer. In the construction process of epoxy floor coating, various problems are caused by various reasons, the most common of which is the spot caused by the local shrinkage of the film surface. The following is an analysis of the causes of spots on the surface of epoxy floor paint: the reason is that too many additives with low surface activity, such as silicone oil, are added to the epoxy floor paint. Solution: control the amount of surfactant such as silicone oil. The reason is that there are too many low boiling point and high boiling point solvents in the solvent or diluent, and the proportion is not appropriate. Solution: pay attention to the use of low and high boiling point solvents and the proportion of various boiling point solvents. The reason is that the grease, wax, metal soap and moisture on the coating surface are not removed. The remaining acid and alkali will remain on the surface of the coated object. Solution: before the construction of epoxy floor paint, the oil, wax, metal soap, residual acid, residual alkali and water on the surface of floor paint shall be removed. The reason is that oil or water is introduced into the spraying process, and the spraying is too close to the object surface.

鲁公网安备 37148202000237号