• 联系人:小马师傅
  • 电话:18560041881
  • 地址:济南市北园大街86号
新闻中心当前位置:首页-新闻中心
    来源:http://www.jndmzp.com/   时间:
    地板铺装施工验收要考虑哪几方面
    来源:http://www.jndmzp.com   时间:2014-12-18 9:07:10
    门扣条的验收:门扣条应装在门的正下方,关闭门后里外都不留边为宜,扣条和门的底部间隙在3毫米—7毫米之间,门能开闭自如。扣条的安装要牢固、稳定,可以用脚踢一下扣条的中间部位,检查扣条两边是否翘起或松动,有无异响。
    Door to buckle acceptance: door button just below should be installed in the door, shut the door after it is advisable to leave no edge, both inside and outside to buckle and the bottom of the door gap between 3 mm to 7 mm, the door can open and close freely. Buckle installation is strong and stable, can be kicked the buckle in the middle of the site, check on both sides of the buckle or loose cock, have the same ring. 
    地板铺装验收:检验地板表面平整度,使用两米的靠尺和塞尺进行验收,标准是每2米内误差值在0.3毫米内;检验两块儿地板之间拼缝的高度差,标准为≤0.6毫米;检验两块地板之间的拼缝间隙,标准为≤0.8毫米;检验地板与墙面及地面固定物(如暖气管道)之间的间隙,标准为8毫米—12毫米之间;检验地板表面光滑,漆面无损伤、无明显划痕;主要行走区域内无明显异响。
    Floor shop inspection: inspection floor surface roughness, the use of two metres on feet and feeler for acceptance, the standard is every 2 meters of error values within 0.3 mm; Inspection flat-fell seam height difference between two rocks floor, standard for 0.6 mm or less; Inspection flat-fell seam gap between two floors, the standard for 0.8 mm or less; Inspection floor and metope and ground fixed objects (such as the heat pipe) between the gap, between the standard of 8 mm to 12 mm; Test the floor surface is smooth, surface without damage, without obvious scratch; No obvious different ring main walking area. 
    踢脚线的验收:踢脚线与门框间隙≤2毫米;踢脚线拼缝之间间距≤1毫米;踢脚线与地板表面的间隙应该在3毫米到5毫米范围内;踢脚线扣口的高度差应≤1毫米。
    The line that play a base of acceptance: the line that play a base and frame clearance 2 mm or less; The line that play a base flat-fell seam spacing between 1 mm or less; The clearance between the floor surface and play crural line should be within 3 mm to 5 mm; The line that play a base port of height difference should be 1 mm or less. 

鲁公网安备 37148202000237号