• 联系人:小马师傅
  • 电话:18560041881
  • 地址:济南市北园大街86号
新闻中心当前位置:首页-新闻中心
    来源:http://www.jndmzp.com/   时间:
    济南自流平讲解环氧地坪的验收标准
    来源:http://www.jndmzp.com   时间:2015-5-7 11:36:46
    1、环氧地坪的环境温度为25℃时,施工后2-3天应达到实干,即硬度达到完成固化的80%左右。
    1, epoxy floor temperature is 25 degrees centigrade, the construction should reach 2-3 days after work, the hardness reached about 80% complete curing.
    2、环氧地坪表面不能出现发粘现象。济南自流平http://www.jndmzp.com/
    2, epoxy floor surface can not be sticky phenomenon.
    3、气泡:平涂型、砂浆型无气泡,自流平允许1个小气泡/10平方米。
    3, bubble: coated flat type mortar type, no bubbles, small bubbles of self leveling allows 1 /10 square meters.
    4、环氧地坪流平性好,无镘刀痕,大面积接口处基本平整。
    4, epoxy floor leveling, no trowel mark, a large area at the interface of basic level.
    5、无浮色发花,颜色均匀一致,大面积接口处允许有极不明显的色差。
    5, free floating, uniform color, a large area of the interface allows a color is not obvious.
    6、无粗杂质,但允许有空气中的浮尘掉落在造成的极小缺陷。
    6, no impurities, but allow the airborne dust fall in tiny defects.
    7、地坪表面应平整平滑,光泽度应达到设计要求(高光泽≥90、有光≥70、半光50-70),平涂型为有光、水性为半光——无光;
    7, the floor surface should be flat and smooth, gloss should meet the design requirements (high gloss over 90, more than 70 light, half light, 50-70) coated flat type for light, water for half light -- no light;
    8、桔皮、砂浆防滑面效果应很明显。
    8, orange peel, mortar anti slip effect should be obvious.

鲁公网安备 37148202000237号