• 联系人:小马师傅
  • 电话:18560041881
  • 地址:济南市北园大街86号
新闻中心当前位置:首页-新闻中心
    来源:http://www.jndmzp.com/   时间:
    济南自流平咬底现象的原因
    来源:http://www.jndmzp.com   时间:2015-10-15 17:20:39
    自流平地坪面涂咬底:咬底是上层涂膜喷涂时.涂料中溶剂对底层产生严重的溶胀起皱而脱离的现象.主要是由于底层未干透就涂下一道、底层固化剂量不足、面涂一次喷涂太厚.这些因素会造成咬底现象.
    Self leveling floor surface coating to bite the end: to bite the end is upper coating spraying. Solvent in the coating of the underlying produced severe wrinkling of the swelling and detachment phenomenon. It is mainly due to the bottom is not dry on the coating under, lack of underlying curing dose, painted face a spray too thick. These factors can cause a bite at the end of the phenomenon.
    本文由济南自流平向大家友情奉献.多有关的知识请点击:www.jndmzp.com我们将倾情为您解答.
    In this paper, we will give you more information about this.

鲁公网安备 37148202000237号